Welcome Here  Shenzhen Mingjiada Electronics Co., Ltd.

sales@hkmjd.com

英banner
Shenzhen  Mingjiada Electronics Co., Ltd.

Service Telephone:86-755-83294757

Product Classification

AI Processor Chip

Resistor network

Home /Company Dynamics /

ATWILC1000-MR110UB Microchip SPI/SDIO to Wi-Fi® Link Controller Module

ATWILC1000-MR110UB Microchip SPI/SDIO to Wi-Fi® Link Controller Module

Source:our siteTime:2024-06-06Views:

Overview:The ATWILC1000 is an IEEE 802.11b /g/n iot link controller module. The ATWILC1000 connects to Microchip AVR/SMART MCUS, SMART MPUs, and other processors with minimal resource requirements via a simple SPI/ SDIo-to-Wi-Fi interface.The ATWILC10…

Overview:

The ATWILC1000 is an IEEE 802.11b /g/n iot link controller module. The ATWILC1000 connects to Microchip AVR/SMART MCUS, SMART MPUs, and other processors with minimal resource requirements via a simple SPI/ SDIo-to-Wi-Fi interface.


The ATWILC1000 supports single-stream 1x1 802.11n mode and has tested throughput up to 46 Mbps UDP and 28 Mbps TCP/IP. The ATWILC1000 features fully integrated power amplifier, LNA, switching, and power management capabilities. The only external clock source required is a high-speed crystal or oscillator.


The ATWILC1000 can be used in Linux, RTOS, or bare metal environments.


Product characteristics

- IEEE 802.1b /g/n 20 MHz (1x1) solution

- Single-space streams in the 2.4 GHz ISM band

- Integrated power amplifier and T/R switch

- Superior sensitivity and range through advanced physical layer signal processing

- Advanced equalization and channel estimation

- Advanced carrier and timing synchronization

- Supports Wi-Fi Direct® and soft AP

- Supports IEEE 802.11 WEP, WPA, WPA2, and WPA2-Enterprise security protocols

- Achieve superior MAC throughput with hardware-accelerated two-level A-MSDU/A-MPDU frame aggregation and block validation

- On-chip memory management engine reduces host load

- SPI and SDIO host interfaces

- Working conditions

- Operating temperature -40°C to +85°C

- Input/output power supply voltage (VDDIO) : 1.62V to 3.6V 1.62V to 3.6V

- Power Supply (VBATT) : 3.0V to 4.2V 3.0V to 4.2V

- Power saving mode

- <1 μA deep power off mode (Typical value: 3.3V I/O

-380μA sleep mode, retain chip Settings (for beacon monitoring)

- Low power sleep oscillator on chip

- Quickly wake up the host from sleep mode via pin or host I/O transactions


ATWILC1000-MR110UB

Parameters

Product Category: WiFi module - 802.11

Series: ATWILC1000

Supported protocol: 802.11b /g/n

Frequency: 2.4GHz

Data rate: 13 Mb/s, 54 Mb/s

Interface type: I2C, SDIO, SPI, UART

Output power: 16.9 dBm, 19.5 dBm

Supply voltage - Min: 3 V

Power supply voltage - Max. 4.2V

Transmission power supply current: 173 mA, 239 mA

Receiving power supply current: 63 mA

Minimum operating temperature: -40 °C

Maximum operating temperature: + 85°C

Humidity sensitivity: Yes

Protocol - Wifi-802.11: WiFi

Unit weight: 16 g

封装.png

If necessary, please contact Mr. Chen:

Tel: +8613410018555

Email: sales@hkmjd.com


Company Introduction
About Us
News Information
Honorary Qualification
Inventory Query
Classification Query
Supplier Query
Help Center
Online Inquiry
Common Problem
Site Map
Contact us

Contact Number:86-755-83294757

Enterprise QQ:1668527835/ 2850151598/ 2850151584/ 2850151585

Business Hours:9:00-18:00

E-mail:sales@hkmjd.com

Company Address:Room1239, Guoli building, Zhenzhong Road, Futian District, Shenzhen, Guangdong

CopyRight ©2022 Copyright belongs to Mingjiada   Yue ICP Bei No. 05062024-12

Official QR Code

Brand Index:

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9

Links:

skype:mjdsaler