sales@hkmjd.com
Service Telephone:86-755-83294757
(TI Automotive IC) DRV8242SQRHLRQ1 6A H-bridge driver with integrated current detection and feedback
Product Introduction:The DRV8242SQRHLRQ1 device is a fully integrated H-bridge driver suitable for a variety of automotive applications. The device is a bidirectional full bridge driver with PWM or phase enable control. Designed with BiCMOS high-power…
Product Introduction:
The DRV8242SQRHLRQ1 device is a fully integrated H-bridge driver suitable for a variety of automotive applications. The device is a bidirectional full bridge driver with PWM or phase enable control. Designed with BiCMOS high-power process technology nodes, this single-chip power package device system provides excellent power handling and thermal performance, small package size and easy layout, but also provides EMI control, accurate current detection and diagnostic functions, and high robustness.
The device integrates n-channel H-bridge, charge pump regulator, high side current detection and regulation, current proportional output, and protection circuit. A low-power sleep mode is also provided for lower static current.
Applications
• Automotive brush DC motor, solenoid valve
• Door modules and seat modules
• Body Control Module (BCM)
• Gasoline engine system
• Car charger
Features
• Complies with AEC-Q100 standard for automotive applications:
- Temperature Class 1: -40 °C to +125°C, TA
• - Documentation for functional safety system design is available
• 4.5V to 35V (absolute maximum 40V) operating voltage range
• QFN package: RON_LS + RON_HS = 250 Mω
• IOUT Max = 6 A (QFN)
• PWM operating frequency up to 25KHz with automatic dead time assertion
• Configurable flutter rate and spread frequency clock for low electromagnetic interference (EMI)
• Integrated current detection (no shunt resistor required)
• Proportional load current output on the IPROPI pin
• Configurable current regulation
Protection and diagnostic performance with configurable fault response (latch or retry)
- Load diagnostics in the off and on state to detect open load and short circuit
- Voltage monitoring on the power supply (VM)
- Overcurrent protection
- Overheat protection
- nFAULT Indicates the fault on the pin
• Support 3.3V and 5V logical input
• Low sleep current: Typical value at 25°C is -1.3μA
• 3 models: HW (H), SPI (S) or SPI (P)
• Single full bridge using PWM or PH/EN mode
• Device series comparison table
Shenzhen Mingjiada Electronics Co., Ltd. supplied and recycled (TI Automotive IC) DRV8242SQRHLRQ1 6A H-bridge driver with integrated current detection and feedback functions.
If necessary, please contact Mr. Chen for further discussion:
Tel: +8613410018555
Email: sales@hkmjd.com
Company homepage: www.hkmjd.com
Time:2025-06-20
Time:2025-06-20
Time:2025-06-20
Time:2025-06-20
Contact Number:86-755-83294757
Enterprise QQ:1668527835/ 2850151598/ 2850151584/ 2850151585
Business Hours:9:00-18:00
E-mail:sales@hkmjd.com
Company Address:Room1239, Guoli building, Zhenzhong Road, Futian District, Shenzhen, Guangdong
CopyRight ©2022 Copyright belongs to Mingjiada Yue ICP Bei No. 05062024-12
Official QR Code
Links: