Welcome Here  Shenzhen Mingjiada Electronics Co., Ltd.

Product Description:

The NCV7535 is a single-chip SPI-controlled H-bridge front driver for controlling DC motors. Thanks to the SPI interface, it contains a useful set of enhancements in automotive systems. This allows for highly integrated solutions.

Features:

• Main power supply function range: 5 V to 28 V

• Main power supply parameters Operating range: 6 V to 18 V

• Active and standby working modes

• Compatible with low Ohm standard N-channel MOSFETs

• Enhanced charge pump for internal high-end power supplies

•N− Dedicated pin for channel MOSFET battery reverse protection

• Programmable swing rate, dead time and overcurrent level

•PWM operating frequency up to 25 kHz

• Active or passive continuous flow

• Continuous flow on the high or low pressure side

• It can be configured in single H− bridge or two-half bridge mode

• 24-bit SPI interface

• Short circuit, over voltage, under voltage and over temperature protection

•TSSOP20 package

• AEC−Q100 certification with PPAP capability

• This is a PB-free device

Typical applications:

• Replace the relay system with MOSFETs

• Motor driver

NCV7535DBR2G Parameters:

Motor type - Step: -

Motor type - AC, DC: brushed DC

Functions: Controller - reversing, direction management

Output configuration: Front driver - Half bridge (2)

Interface: SPI

Technology: NMOS

Step resolution: -

Application: Automotive grade

Current - Output: -

Voltage - Power supply: 4.75V ~ 5.25V

Voltage - load: 5V ~ 28V

Operating temperature: -40°C ~ 150°C (TJ)

Mounting type: Surface mount type

Package/housing: 20-TSSOP (0.173", 4.40mm wide)

Supplier device package: 20-TSSOP

Basic product number: NCV7535

We (supply, recycle) onsemi (NCV7535DBR2G) FlexMOS™SPI controlled H-bridge and double-half bridge front drivers, if necessary, please contact Mr. Chen for consultation!

Contact information:

Email: sales@hkmjd.com

Company website: www.hkmjd.com