Welcome Here  Shenzhen Mingjiada Electronics Co., Ltd.

Shenzhen Mingjiada Electronic long-term acquisition of TI millimeter wave sensor AWR1443FQIGABLQ1 integrated MCU and hardware accelerator single chip 76GHz to 81GHz automotive radar sensor

Device Description

The AWR1443FQIGABLQ1 device is an integrated single-chip FMCW radar sensor capable of operating in the 76 to 81 GHz band. Built on TI's low-power 45nm RFCMOS process, the device features an integrated ARM R4F processor and a hardware accelerator for radar data processing, providing excellent integration in a very small package.The AWR1443 is an ideal solution for low-power, self-monitoring, ultra-accurate radar systems in the automotive space.

The AWR1443 device is a self-contained FMCW radar sensor single-chip solution that simplifies the implementation of automotive radar sensors in the 76 to 81 GHz band. It enables a single-chip implementation of a 3TX, 4RX system with built-in PLL and ADC converters. Simple programming model changes support a variety of sensor implementations (near, medium and long range) and enable dynamic reconfiguration for multi-mode sensors.

FEATURES

FMCW Transceiver

Integrated PLL, transmitter, receiver, baseband, and ADC

76GHz to 81GHz coverage with 4GHz available bandwidth

Four receive channels

Three transmit channels (two channels can be used simultaneously)

Ultra-precise linear FM pulse engine based on fractional N PLLs

TX power: 12dBm

RX noise figure:

14dB (76 to 77GHz)

15dB (77 to 81GHz)

Phase noise at 1MHz:

-95dBc/Hz (76 to 77GHz)

-93dBc/Hz (77 to 81GHz)

Built-in calibration and self-test

Arm Cortex-R4F-based radio control system

Built-in firmware (ROM)

Self-calibrating system for process and temperature

On-chip programmable core for embedded user applications

Integrated Cortex®-R4F microcontroller clocked at 200MHz

On-chip bootloader support for autonomous mode (loading user applications from QSPI flash)

Integrated peripherals

Internal memory with ECC

Radar hardware accelerator (FFT, log-amplitude calculation, etc.)

Integrated timers (watchdog and up to four 32-bit timers or two 64-bit timers)

I2C (controller mode and target mode supported)

Two SPI ports

CAN port

Up to six general-purpose ADC ports

High-speed data interface to support distributed applications (i.e., intermediate data)

Host interface

Control connection to external processor via SPI

Interrupts for fault reporting

AECQ-100 compliant

Advanced Device Features

Embedded self-monitoring, eliminating the need for a host processor

Complex baseband architecture

Embedded interference detection

Power management

Built-in LDO network for enhanced PSRR

I/O support for dual voltage 3.3V/1.8V

Clock Source

Supports externally driven, 40MHz clock (square/sine)

Supports 40MHz crystal connected to load capacitor

Easy Hardware Design

0.65mm pitch, 161-pin 10.4mm × 10.4mm overmolded BGA package for easy assembly and low-cost PCB design

Small footprint solution

Operating Conditions

Junction temperature range: -40°C to 125°C

For stock disposal, please call Mr Chen:

Tel: +86 13410018555

Email: sales@hkmjd.com

Company Homepage: http://www.hkmjd.com/